A signal from an IC's internal function is applied as the base input for a NPN BJT transistor, which controls the transistor's switching to the IC's ground. Open collector NPN open collector output schematic. ![]() Open outputs using PNP and pMOS transistors will use the opposite internal voltage rail used by NPN and nMOS transistors. The NPN BJT (n-type bipolar junction transistor) and nMOS (n-type metal oxide semiconductor field effect transistor) have greater conductance than their PNP and pMOS relatives, so may be more commonly used for these outputs. Analog applications include analog weighting, summing, limiting, and digital-to-analog converters. External pull-up/down resistors are typically required to set the output during the Hi-Z state to a specific voltage. These open outputs configurations are often used for digital applications when the transistor acts as a switch, to allow for logic-level conversion, wired-logic connections, and line sharing. Open outputs configurations thus differ from push–pull outputs, which use a pair of transistors to output a specific voltage or current. When the transistor is off, the output is internally disconnected from any internal power rail, a state called "high-impedance" ( Hi-Z). One of the IC's internal high or low voltage rails typically connects to another terminal of that transistor. ![]() Open collector, open drain, open emitter, and open source refer to integrated circuit (IC) output pin configurations that process the IC's internal function though a transistor with an exposed terminal that is internally unconnected (i.e. Transistor switch output for integrated circuits
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |